Recent content by lose_money

I would sell you my SAE-600 for cheaper, i bought it around 3 weeks ago i want to buy something a lil bigger

Haha thanks for the help man it sounds miles better now. Pushing way more air I don't know if it's from repositioning it or the wire change but it's better. I would try and put it under the seat or something but the box is way too big I don't got any other opinions besides on the seat. The only...

Thanks man for the info, what i did was lay the sub down and face the port and sub towards the back of my drivers seat now. I also got my 10 gauge wire in the mail. When I swapped out the speaker wire I realized the old wire was 16 gauge. It made a big difference after swapping out the wire...

A lil confused about the bricks. My sub is mounted on top of box also with the port being on top. I'll upload a pic a lil later

Yea im wired to 1 ohm

It's top firing and its on the back seat of my tacoma double can. I set the gains with a dmm too   ---------- Post added at 07:10 AM ---------- Previous post was at 07:09 AM ----------   Yea I guess it could be my expectations are too high

I recently bought one sa-8 v2 2ohm and had a custom box built to spec. I also bought a sae-600d amp from sundown and went ahead and installed everything. My one issue is i don't think is performing to what it's supposed to from watching videos and hearing reviews. It doesnt get to loud and...

still got the amp?

Alright thanks I was just hesitant to do that because it goes from -15 to +15 so I thought the 0 point would be normal preout amp voltage

So could this be why it doesn't seem like my sub is reaching its potential beacause i sent my gains high due to my preamp output being low because of my sub level being at 0 on hu?

Sub level on max when setting gains? And then bring them back to 0 after? My amp is a monoblock my door speakers run off the deck

I would consider it a medium level deck. It's a Kenwood Excelon KDC-X697

I set the volume at 26/35 with and all sub level control at 0 and bass at 0. What do you mean by more power at higher volumes without clipping. I also have been running everything at 0 since i set up. It pounds but I feel like it should pound a lil more from the videos and reviews I've seen on...

Thanks man yea that clears it up a lil. I forgot to mentioned im wired for a 1 ohm load. I just was a lil unsure cause I see a lot of ppl saying keep your gains low

Quick question i recently bought a sa-8 v2 and had a custom box built tuned to specs provided. I also bought a saw 600d and set it up. I have a kenwood deck with preout of 4v. When setting my gain with a dmm i had to set gain around 75% to achieve the desired voltage at 3/4 volume on my HU. Is...