Recent content by LeV

You can now download the new Spring 2003 Alpine catalog (2.1 mb, PDF) from their website. It lists all the new models and more.

There are a total of 10 adjustment modes with the M500. 1. The input mode: obviously you figured it out or you probably wouldn't have any music. 2. The Low Pass Filter is a -24db filter, which attempts to clean up the bass between 30 - 200Hz. Mine is currently off because I heard no...

I have two sets of Alpine components up front, both 4 ohm. I've wired them in Parallel, which produces a 2-ohm load at the amp. Will it hurt the components to run them at 2-ohm when they specify 4-ohm? Thanks!

Well considering the drivers will only play down to 40kHz at best I can't be far off. My problem will be configuring all the speakers to sound good together as a whole. The drivers try to play too much of the bass.

In the front doors I have a pair of, 6 1/2" alpine SPR-176A mids (2 in each door) with one tweeter. In the rear is one set of SPR-176A's and a Alpine 12" SWR-1241D sub in a simple sealed enclosure.

Hi Everyone, I have a question about my Alpine MRV-F450 5-channel amp. I'm running 2 sets of drivers in the front doors, one set in the rear doors and a single 12" sub. Everything sounds good, but I'm wondering what my crossover points should be, and if the low-pass & high-pass filter...