Recent content by lavapants

I have a crimestopper CS-2011 IV installed in my 94 Chevy S-10. The problem is whenever I disarm the alarm the get a constant beep. Another problem is any siren i put into the unit gets shorted out after installing it. So since i have no siren i believe when i unlock the truck to disarm the unit...

I got my truck a few months ago and since i got it have had problems on finding a box to fit in my extended cab. I do not want to lose my two jump seats, and the only place i have found a custom sub box is http://www.jlaudio.com/stealthbox/s10_extended.html but i am concerned with the cost of...

I believe i am gettin a crimestopper within the next few days. I plan on doin the install myself with my friends. I have read on this forums about a program called Techsoft to help you figure out where the wires go. I have looked but could not find the program anywhere. Where do i look for the...

I am planning on running one 12" sub out of my chevy s10 extended cab. I was considering JL w3 or some type of audiobahn sub. Which sub brand would be best to get. I am looking to hit hard and sound good. I kno audiobahns hit hard but do they sound good? Any suggestions would be great

I have a 1994 Chevy S-10 Extended Cab. I have one 12" Sub, and i want a custom enclosure designed for my truck to install the sub. I have looked all over the internet but only found a 10" enclosure, and most are for regular cabs only. Unfortunately I do not have the time to build a box otherwise...

yeh i believe it got too hot....is there any way to get it out of protection mode??

I was driving around 1 day and my bass was goin pretty good and then all of a sudden my subs shut off. When i got home i checked my amp to see that the amp was still powered but the subs were making no noise whatsoever. Does any1 know why my subs are doing this and how i can fix this thanx

well i went back n checked all my wiring today and it turns out my ground to the car wasnt good enough. I made the ground better and it all works now. Thanks for the help

All three have their own power wire going to a distributor block. When all 3 are connected the crossover seems to short out the other 2 amps. But like i said when the 2 amps are only connected they power up fine. Maybe the remote wire for the crossover could be bad

Ok heres my scenario I hook up my 2 amps to the remote wire and they go on I then connect the crossover to these remote wires and the 2 amps shut off n the crossover stays on I have tried a relay like suggested and still have had no success its not the remote because I put a 12v wire from...

Does it matter how many amps go into the relay? Or can it just be right off the 12v car battery into the relay? Also i have a power antenna

how would i wire it and wut would that do

I have 2 sony xplod amps and an mtx crossover. The problem is i'm not gettin enough power to run all 3. When i connect the remote wire coming from the head unit to the other 3 remote wires the crossover gets full power, 1 sony xplod amp gets power n then shuts off and then the other amp doesnt...