Recent content by latreche34

Here is the installation diagram:

I just figured out that the Amp has an internal 3-way active crossover for front, rear and sub so I'm just gonna use it to make installation easy, I don't think its going to be a big difference in sound quality vs external crossover.

If you think using active is ideal I can get a pair of those in the link in my previous post and use only the front or rear outputs of the HU and turn off all HU internal crossovers and feed the 6 outputs from the two active crossovers to the 6 inputs of the amp. I don't know if it's true or...

Upon browsing the head unit manual I found out that it is built in active crossover HPF and LPF, however HPF is adjusted for both front and rear outputs and not individually, while the LPF for the subwoofer output is as follows LOW/55Hz MID/85Hz HIGH/120Hz. At this point I'm not sure if I set...

Thanks for the reply, I have heard bad and good about this amp but I think It will be ok for what I'm setting it up for, Anyways so you think the sub out from the head unit is crossed over to low freq already so I only need a 2-way crossover for mid and high rather than 3-way? Do you think...

Although this is a car section but my application is no different from a car system install, I'm planning in installing Pyle Audio PLAD618 to the head unit JVC KW-HDR81BT in a shop built wooden music center box, both head unit and amp have 6 channels inputs/outputs, On the head unit side they...