Recent content by kwhitelaw

Next time, I would glue the alpine trim ring into the hole you cut. Then you are guaranteed a perfect gap around the unit and no problems with the motorization. It looks good though. Hopefully now people will understand why shops charge alot to do this type of work. I would have prolly 2-3 full...

One wire powers the radio, the other wire powers the CENET connector for changer/TVtuner/sat radio,etc. Hook them up together and be done.

What exactly do you want to know? Where to run the wire? Take it down the drivers side of the car. There is a big grommet under the dash you can go through. You will need a battery post adapter for your battery terminal to hook up to.

The dash piece pops off. Do not try to remove the tray up top as there are screws under the dash piece to remove it. Very carefully pry down low till a corner comes up then slide your fingers behind the piece and drag them up. Only use a tool to pry it first then your fingers as you will feel...

Okay, you are making this harder than it has to be. Take your monitor apart and use just the housing. Tape off the buttons. Cut around your dash piece on the sides so it clears and near the top if need be. Use caution around factory buttons, etc. It is hard to tell what is there under the tape...