Recent content by kmoto

Thank you everyone for your input. I learned a little something from everyone who posted. Just some observations I made... One way, you set the boundaries at the outer shell of the vehicle with multiple layers of deadener and try to deaden everything between you and the outside shell . Another...

I think you should investigate the Ohm load of your speakers and the ohm load you are putting to your amps. Also some amps have a limit on the pre amp voltage (4v ,5v). Turn your gain down. 6 X 9 's are useless . They will always sound bad at high volume and for the same money you could get a...

Is there any need to put anything else in the door besides sealing so waves don't meet and enough deadener to lower the resonance to a respectable level? CCF,eggcrate,.... it seems to me waves would bounce off of sound deadener because of its density. Wouldn't a material that increases surface...

film lined fiberglass absorbers? pics? I did not think about 3" thick sheets of polyfil but they use it in home cabinets.

Thanks for the input guys. If I could just bring myself into alignment with the 25% coverage philosophy I would be sold. It makes sense but not many people are doing it with reviews . I did read a couple. I would hate to buy good speakers then fall short of their abilities. Is there a specific...

Pico fuse?

So I want to do this SQ door install right . I don't plan on CLD tiling the whole vehicle just the doors and a couple key areas. I have a 2001 jeep Cherokee XJ . I plan on putting these H.A.T. Clarus in the front doors. I made some oak angled speaker rings out of an old chair (1.5" to 1"...