Recent content by kar7076

  1. K

    I'm unsure of how to do my wiring harness

    I just bought a new deck and now its time to assemble the wire harness, well i was told that soldering is the best way, but I don't wanna solder my harness until I have my permanent wire laid out in my car. What is good to best speaker wire to use in a car? Specifically for front and rear of cab...
  2. K

    I just bought a Kenwood

    Alright thanks a lot. Im still anxiously awaiting the deck.
  3. K

    Connectors for my Wiring Harness

    Where can I find information on soldering my wiring harness? Like what kind of solder do I need, are there different grades or ways to measure the quality of solder, what kind of soldering iron should I use? Also, how should I go about soldering the wires" Stuff like that.
  4. K

    I just bought a Kenwood

    Alright thanks. I noticed on mine the outputs are 4v whats the high-end of preamp output voltage? Fathom I noticed you have the list of speakers, the orion comp good?
  5. K

    Amp Power Cable In Focus

    The grommet is just a circular rubber piece that holds the tubing(wires) going through it. If you can find one, just make sure you know where the other side is inside of your car, I suggest you get a book for your car because this part can be tricky. Then just make sure its safe to do this, and...
  6. K

    Connectors for my Wiring Harness

    Thanks, also I prolly will have my front and rear speakers on my deck for a lil while, is it worth it to run speaker wire through my car and crimp/solder it to my harness? What size speaker wire should I use. I had some 14g wire Running from my deck (crimped to the harness with butt connects)...
  7. K

    Connectors for my Wiring Harness

    I was thinking about using crimp-on snap connectors to connect the two halves of my wiring harness when I get my deck later this week. Are these connectors good/bad? What else is better with the same ease, or just better? Thanks
  8. K

    I just bought a Kenwood

    Nobody messes with Kenwood here?
  9. K

    I just bought a Kenwood

    I haven't even received it yet, I ordered it from Crutchfield. It was the KDC-x589, does any body have any opinions/comments on this deck, even though I already ordered it, I wanted to know opinions since I just joined the forum. In advance I appreciate all yalls comments
Top