Recent content by Justshoe

Anyone know if the alpine unit works better than the terks also?

No i have nothing else on ai-net just the xm adapter....

Well i just got the terk direct setup for my alpine 9853. And i cannot get it to recognize the xm radio when i hit source it never goes to an "XM" ive tried playing with aux in on and off and goin to that source and d-aux. Tried switching the ai-net switch on the bottom side. Anyone else hook up...

What you lookin to get for monitor.

The thing is that factory amp is fairly low wattage and the wiring to it is not designed for an aftermark amp. Your preety much limited to replacing factorys and then running a new amp. According to your sig you already have a sub amp back there? What kind of wire size you have running to it...

Im guessing that may want to overpower the circuit. Reguardless you should have that circuit fuse and it'll blow if it does. But i wouldnt suggest it. Check your fuse box you should have another circuit thats available for easy taking of the power. if its possible to just fuse it there good...

Still going to need at least 4gauge and set or 2 of rcas running back there. What might be a decent idea for RCAs is to run them right down to the center console under the console then into the carpet as opposed to tryin to run them across the dash and along the sills.

I doubt the PCM will cause noise. Its actually a fairly low current device. Guess bad HU ground or even possibly that remote.

Right now i have audiobahn aw102t's. Do you think goin to RE RE 10s is gunna change much for spl? I have a .9 cu ft for each sub. In a truck box.

I have a 9853 and havent one complaint about it i dont see what the big deal is about the glide touch i havent had a problem with it at all.

YI do exactly what sniper said. Use a coax crimper and then solder after.

I wouldnt worry about it if your sure thats the problem i dont see what it would cause other than an annoying light.

Check your fuses that R/Y i believe is your illumination B+ im looking at a diagram now and fuse 1 is the B+ for that so check your fuses maybe it somehow hit ground and blew the fuse.

Anyone know of a good 10" SPL sub with low box volume and low mounting depth? I kno they both make spl worse but i have a reg cab truck witha box that you need nothing more than 5" mounting depth and i have about .8cu

Actually stones its better to do that on the ground side. Get a test light and go from batt post - to the cable - take off cable and put a test light between them. Depending on the vehicle and how many computers it has it may take up to 45 mins for them to shut down like this. So what you would...