Recent content by justind

I gues my main question is how to figure the proper amps to run to the crossovers. Do I add qll 3 speakers together?

I am looking at a 3 way system. It is a MBQUART two with a 4 and tweeter with a add a woofer 6.5". The two way components state they can handle between 40-100 watts. The added 6" woofer says it can handle between 80-150. When I run power to these speakers, do i run one chamel for the...

DawgDan, pm sent. Go Dawgs!

When you talk about guague of wire, are you refering to the power wire or speaker wire. I was planning on using 16 guage wire. Is that not low enough?

I listen to mostl rock and some hip hop... I dont need anything that will rattle the car apart.. Just looking fr a good clean sound.. If I used the 4 chaneel amp, could i use one channel to each side for the 4s,6s, and tweets and then bridge the two remaining channels together for the sub...

any other ideas? Would the 12 be more apropriate?

Thanks for all the great responses.. I was also thinking it may be best to get a sperate amp for the sub. Maybe I should move up to a 12 for the sub with a seperate amp? If I did that, could I use the 4 channel amp to power the tweeters, 4s in the dash, 6s in the doors, and the 6x9s in the...

Unfortunately i do not know how to install it myself. I dd compare some of the major units based on Ebay and they were not too bad.

Hello all. Great Forum. I have spent alot of time searching. I also went to a installer yesterday and here is what we are thinking for my system. QSC210 4" Q Series Components with tweets. (4s inthe dash and tweets on the pillar) QSC164 6" Q Series Midbass add ons for the front doors MB...