Recent content by jucaraman

I deff need to tune em in though they arent set quite right yet, but sounding 100% better already.

I fixed the polarity you were right on of the wires was backwards, I put the 9volt and it sucked in and the other pushed out so I switch it and ta da, then I piggybacked the wires, and bridged it mono 2ohm, and drove around for about 20 mins slammin pretty good most the time, and when I got out...

hmm I guess ill find out Ill have to let you know Ill get you a picture of my box I just finished tonite sometime tomorrow

but removing it once, or twice wont matter much will it, once I get this corrected I plan i keeping it closed for good.

on that 9 volt test what will the sub do if the wiring is incorrect on the sub (inside box on sub)

ok, I will stop doing that then immediatley sometimes my friend will try to get alittle to helpful, and start pulling the rcas and switchin them and stuff :S but i never had the system up above volume like 5 barely moving sub, during this.

yeah I am maybe thinking in wiring the subs before I put them in the box, I might of wired a - to a - on the speaker or a + to a + on the speaker. will unscrewing the subs, weaken my boxes sub holding strength? I wanna make sure the subs stay scewed in tight, after I spent all the time building...

I think my polarity is jacked, ill see what I can do

ok i understand, I just wanna thank you for the help, I cant wait to get out there tomorrow and mess around and see what I can find, the whole sounding good running off of 1 rca wire outta the set it just confusing me?? doesnt make sense, then when you plug the other one in it makes the sub pop...

is there a quick way to check my polarity is correct without removing the speaker from the box?

It doesnt have any warning lights or anything on it

when you say cutting out will it shut off or what?

cool thanks, what if I did the one above? Would I gain more power?

according to that it should be 2 ohm right?

dual 2 ohm I believe