Recent content by jrouter76

Oh ok hmmm

Redo the pinched cables

Yes he was a constant poster here for many years,talking about a blast from the past..lol

get in contact with kicker,tell them what happened and go from there...if they are willing to work with you go that route if not look into SSA subs or Sunddown Audio,or Stereo Integrity ,or any other good quality Subs

is that a Octal-aero port? nice badass zcon sub

just a thought,disconnect the POS on the battery let it set for 30 seconds then connect the POS back up on the Battery, this should reset the HU,

so which wire is for Memory on your HU if yellow is for remote or Ant.

If THX0ne suggestion does not solve the problem, run the power(red) and (yellow) wire together to a fuse in the fusebox that`s Hot(on) constantly and Ground the Black wire to a known ground-wire or grounding point on the car...this will telll if there is a wiring harness problem in the Dash

NO and NO crossovers control Frequencies NOT ohms look up Ohms Law

try replacing the RCA inputs on the amp`s board itself,requires that the inputs be desoldered from the main board and replaced with new ones.

Exactly the reason whyI have done this with my other car and I sealed up the doors and sound-deaden them very well and the MidBass sounds damn good...I thought this out for over 2 months and this will work without using any screws to mount my rings Its going to be sealed correctly

2004 Bonneville SLE

No this works for me.... see the factory speakers mount from the inside of the door panel see picture

? why a jigsaw...the speaker rings are going to be mounted on the outside of the door panel exactly where the factory speakers and grill are.No need to cut anything

@Coolhand20th got my rings last wek and they are what I needed thanks,now i`m going to use 3M VHB tape to bond them to my door panels.