Recent content by jparmyguy

  1. J

    Dual 4 ohm subs to monoblock

    Ok my bad sorry im not the best typer. If it was a dual coil it would have 2 reds and 2 blacks on each sub
  2. J

    Dual 4 ohm subs to monoblock

    Single because it only has one black and one red per sub.
  3. J

    Dual 4 ohm subs to monoblock

    I read that but my subs are single coil so would it only drop down to 2? Like they only have one red and one black each
  4. J

    Dual 4 ohm subs to monoblock

    Thanks so it should be fine to do that but im kinda confused if it will drop it to a 1ohm load or 2 ohm because the minimum my amp can handle is 2 ohm
  5. J

    Dual 4 ohm subs to monoblock

    I am just really confused about some of the terminology
  6. J

    Dual 4 ohm subs to monoblock

    This is the amp Precision Power PPI i650.1 650W Monoblock iON Series Class D Digital Amplifier
  7. J

    Dual 4 ohm subs to monoblock

    I have 2, 4ohm kicker 12in. They are placed in a dual enclosure with separate box terminals for each one. What impeadance would i get, and is it ok, that i have 4 wires coming out of the mono block amp to go to each box terminal individually. Do I need to wire them so that only 2 wires are going...
  8. J

    Subwoofer Playing Quietly Problem

    I drove around with them on half for excess amount of time and nothing happened. They both cut out when it was snowiing and below freezing
  9. J

    Subwoofer Playing Quietly Problem

    After installing 650.1 the subs are still not working they produce sound but do not move, hence the quiet noise? I am not sure what the problem is the terminals read at 4ohms
  10. J

    Precsion 650.1

    I am using the speaker level input, do i need to connect both right and left side speaker or is the right sufficient? Is it necessary to ground, if so can i ground on same spot on the chassis, for the amp ground?
  11. J

    Subwoofer Playing Quietly Problem

    Are there any safety precautions because im going to use 8? excess heat?
  12. J

    Subwoofer Playing Quietly Problem

    What about the 1000? I plan on testing the subs with multimeter tommorrow if there still good then im gonna buy 650. If not I will buy 1000 with better subs in the summer time. Again out of curiosty do you reccomend any setup to go with 1000 watt? I have 2011 Mitsubshi lancer
  13. J

    Subwoofer Playing Quietly Problem

    I Have 8 gauge wire ran for the power. Would I have to rerun all the wires?
  14. J

    Subwoofer Playing Quietly Problem

    Robot Check That is the sub + box combo im hoping that them playing quiety does not mean they are permantly dead nothing more than 200 dollars
  15. J

    Subwoofer Playing Quietly Problem

    Could you recommend a good amp then to switch too?
Top