Recent content by jler5958

  1. J

    alpine mrx-m240 going in to protect mode

    Anybody have an ideas on what it might be
  2. J

    alpine mrx-m240 going in to protect mode

    It is a 4 channel eq, I've tryed hooking up my rcas directly to my amp with out the epicenter but it still cuts out, and even with my eq rcas I have also done the same and it still cuts out, could it be the head unit?
  3. J

    alpine mrx-m240 going in to protect mode

    Ok that is how I have it set up, so what do I do then if my head unit only has 1 pre output IN the back? So u think I should take out the eq?
  4. J

    alpine mrx-m240 going in to protect mode

    I have an eq hook up and an epicenter also and a door speaker amp also do u think any of those many be causing the problem?
  5. J

    alpine mrx-m240 going in to protect mode

    I've turned the gain down but it still does it, the big 3 I haven't done I'm not too sure my alternator can handle it because it's a stock alternator, and yes I've check all my wirings and even 're did them but still for so reason it cuts out and I can't even put my subs to 2ohms for the fact...
  6. J

    alpine mrx-m240 going in to protect mode

    I have an alpine mrx-m240 with 2 alpine 12in x types wired at 4ohms but when I turn the volume up on my head unit it goes IN to protect mode I checked my power, ground, rem, fuse, and rcas and for some reason it still cuts out when I checked the voltage I get about 13.6 volts with the truck on...
Top