Recent content by jinx8402

Yeah, I mirrored it on purpose. This way when looking at the diagram, it resembles what you would see from inside the box

I was originally going to go the switch route. However I'm scrapping that and going to go with just manual wire switching. Like you said, I don't want a failure, and I knew there was a chance of failure with either the relay option or switch option. Of course, I was intending on doing all...

Hey Guys, I'm looking for some help on determining which switch I need for my install. I want to have a switch that switches my dual 2ohm voice coil sub from series to parallel and vice versa. I have found this article on Instructables on how to go about this, which is fairly straight...

Pending Payment

No sorry. Just bought my new amps. Shoot me an email if you are still interested though.

I have a PPI PCX 4125 for sale. Works perfectly. A few light scratches, nothing major though. Amp is rated at 12 volts, and can do 4x125 or 2x500 or can run 2x125 and 1x500. damping factor of >500 s/n ratio of Harmonic Distortion >.02% Front and rear crossover section is 12db fully...

No, this was a spl bass contest. I couldn't tell you what frequency he used...but I would assume it was some type of bass track/sine wave. Also, my point wasn't that they don't get loud. Because they do. It's just that they have virtually no low output, atleast not in the applications I see...

I wouldn't even say the SPL is great on these things. Most people use them for midrange because they get loud. Someone actually entered a competition with 4 12" EV's and only metered a 125 or something like that. They don't get loud on the low end. What's worst, is they don't mate them with...

My brothers old system did that as well. We always assumed it was just how the amp was designed to protect either the amp or the sub. We actually liked it, because the system would come on, then a second later the bass would kick in...lol

second: I've never known any amplifier to require two power and two ground wire inputs. I cannot seems to find a good picture of this amp's wiring so i could be wrong. My brothers infinity beta digital amps used 2 seperate power and ground connections. For his particular amp, the reason was...

How many watts does that battery put out?

On a very broad scale....since you gave no specifics...if the final load was 4 ohms to the amp, the amp will generally run cooler. If the final load is 2 ohms to the amp, you can buy a smaller amp, due to the power generally doubles from 4 ohms to ohms. Ex. You have 2 woofers, both handle 500...

Yeah, I wouldn't put them on the level of Zapco, or other high end amps. I would say the only reason why you should consider "down grading" (I hate using that term because they are good amps) to the Alpine would be because you want smaller amps. I went from PPI PCX amps to these, for that sole...

Yup, no complaints concerning my PDX amps I just installed. They are mind-boggling small. I love it.

Don't forget you can turn off the internal amp if you are not using it to power any speakers. You can get to this the same way as changing the illumination by having the unit off and holding the right knob in.