Recent content by Jibbercrap

If I remember right they are 400watts RMS each and 4ohms each SVC not sure if they are dual or not. id have to look at them again. so as far as i know they are single voice coils at 3.5 or 4 ohms each

I want to get good amp to run my 2 soundstream exact 10s...they have been sitting in storage for awhile and i decided to bring them out. I dont want to spend tooo much $$, what would you guys suggest?

ANother way is to get the schematic drawing for the amp, also with it get the parts list...every manufacturuer will have those. They should e-mail them to you if you bug them enough =P lol worth a shot.

The wont necesarily be the same...matter fact they are most likely different. Try to get a number off the parts or send the amp away cause there could be damage to other components that might not necesarily look burnt. Looks like the bottom corners of the board is burnt black =P lol...musta...

Try to over-rate the parts by 20% ...good rule of thumb to go by when repairing electronics. Say its rated to handle at max 5amps, get one thats capable of handling 8amps...avoids blowing the part again.

Does each have 3 prongs coming out? they sound like the voltage regulators...easy to replace IF you get the exact ones...if not your amp wont work the same or wont work at all. Also make sure that its only those that are blown...me and friend recently tore apart a home amp and there were burnt...

You take the output from the amp and multiply it by the resistance of the subs...not the RMS value of the subs multiplied by their resistance.

Sounds perfect for my setup too...how much do you think its worth?

ya 2 10s tend to sound the best for a rock setup

Try looking up the Mempis PR1000D...its 1000RMSx1 @ 1ohm. A few of my buddies use these...**** nice for the money

You shouldnt have too much trouble running the 801D. Id go for the 2 W3s over 1 W6v2.

hmm but would they really sound better then the 2 12' coustic CFs??

Check out Memphis, their PR series is decent and priced relatively low

They were selling em around $125 a piece (canadian dollars) for the 10s, i think around $135 a piece for the 12s...since my friend works there I usually get a bit of a discount because im one of the store 'groupies'. But ya, I was gonna MAYBE once I get my taxes back see where im at and maybe...

I know the W3s can handle a lot more then they are rated for...they can easily handle around 500watts RMS each or more. Hell we had W0s running at 400watts RMS.