Recent content by jdeaton011989

Tupelo area

And of course I'm not finished just did what i had to go get it playing. Got to cover it with something .. Now I got to learn to sew lol

I built a slot port. I didn't have enough space under my box for the port but I'm extremely happy with it. It's 2 cubes net at 33-34 Hz. There ports 2 3/8" wide 33.75" long. Thing is loud and sounds good doing it

I can't find what exactly sch35 pvc is... Most charts I see show 3 1/2" as 4" OD. I search sch and sdr Comes up..

They come out of the bottom. Three measurement that says 1'10" is the ports It's a dotted line showing how they are inside the box.. Kinda hard to make it sorry. I think it's and 2 1/2 inches at least from center of port to wall. I've read that the rule of thumb is to keep it a diameter length...

This is my drawing

One last try

It's not I'll get a better picture

This may be a Better picture

The dotted line is where my port will be.. Out don't have a lot if breathing room but I think it'll be ok.. Any thoughts?

What's this look like?

Alright thanks.. I may go slotted I just wanted to go there best route to eliminate port noise bc it's in a cab of a truck. If I go that way I think I cab figure it out . I've been playing with the software. Thanks man. I'll post when I get it built.

Yea I should... And I will. Just one question, will it kill my output if I fire the ports under the seat?? Learning. The programming won't tell me why I need more port volume.. But I've learned a lot already I appreciate your time.

I want a flatter response so I should go with a port area close to what I have right? I don't want it to be peaky

So why do I have to have more port area?? It requires more bc I'm ruining a 1000-1400 watts??