Recent content by jct404

  1. jct404

    Down Fire Clearance?

    yeah I ready that on the previuos post thanks for the idea.
  2. jct404

    Down Fire Clearance?

    I stared on the box last nite I didn't get very far, but I sure knocked the s#!t out of a 12 pack. Anyway the box is going to be sealed, the sub is in my sig. I don't think the P2's extrude very much. I was thinking around an 1" to an 1-1/2" off the floor. I don't think it is possible to do a...
  3. jct404

    Down Fire Clearance?

    I'm looking at building a single 12 down fire box for gmc crew cab. My question is how much room should I allow between the floor add the sub?
  4. jct404

    Power Feed Question

    4 to the block 8 to the amps?.....I wasn't sure how big I needed to go. I don't plan on add too much more in the future. I may up grade the alpine someday.
  5. jct404

    Power Feed Question

    I have an 8 gauge wire running to 3 amps, a 400w, 200w and 100w. Is it too small? If so, if I run another 8 directly to the 400w and split the 200w and 100w off the other feed will that work. Also what amp fuses would be correct. Or if anyone has a better solution feel free. My stuff is in my sig
  6. jct404

    Power & RCA Wire Feed Back

    Thanks for the replies, What about the speaker wires coming off the amps? Should I maintain a separation between them and the rca and or power cable.
  7. jct404

    Power & RCA Wire Feed Back

    I have been reading various posts about RCAs picking up power frequencies from the power wire and causing the subs to rumble. I think this may be my problem. Both wires run together to the rear of the truck. I can take my foot and push on the floor board where the wires are located and the subs...
  8. jct404

    1997 DODGE RAM 4x4 LIFT w/ 10in and w/ 4-alpine type R's and US AMPS MD2D

    Nice rims & tires! Lookin good, Throw a set Bushwacker Flares, Pocket style cause you sure don't need the cut outs with all that room.....bushwacker.com/dodge.asp
  9. jct404

    Direction needed

    I went with Rockford. I really wanted to go with JL and get it all off Ebay, it was going to be around $1200 which I was willing to do but my "better half" was b!tI sounds pretty good, probably not as good as it would of been but I'm satified. Saved a some money....and the she quite
  10. jct404

    Direction needed

    Thanks for the shit advice Mac. I went a different route!
  11. jct404

    Direction needed

    I am newbee to this forum..... I am looking to get two amps, a mono around 500 and 4 way somewhere around 300 to 400 watts. I 99% sure I am going to get two 10" JL w6 for the subs. My question is would I be a fool not to go all JL or is there something that is comparable performance wise for a...
Top