Recent content by jbang917

x2 do the research and give us the specs and then we can make some good suggestions.

Fosgate makes up to a t2500 mono amp. I want to keep it mono but I was thinking about doing the smaller amps so I could run at 2ohms for better efficiency and still get a couple thousand watts to each sub.

So what you are saying is that if I build the enclosure to a specific dimension I can "expand" if you will, the limits of my suspension and mechanical parts?

RF rates the t1500's at 1000 watt @2ohm. So I figure run each VC on its own seperate amp and I should be nearing the limit of what my sub will handle. Basically I got the batts on their way so I will take care of them first. Once I eventually get the amps in I will see how the car takes that...

Went ahead and ordered my batts. I will be running a total of 2 kinetic 800 and then replacing my stock with a 1400. Got a TON of 1/0 so hopefully I will be done with some glassing projects when my batts get here so I can focus on some wiring. For the sake of keeping it RF I think I am going...

Thanks for that. Right now in their current setup they beat down the block. They have been more than I ever thought they would be. 2000 on each driver sounds REDICULOUS! RF must really underate these things... 1500 watts to each vc sounds like alot too but it also sounds like what I am...

Voltage drop sounds like you got too much bump for your electrical. When you stop your RPM drops to idle compared to driving when your rpm is like 1500 plus. Lower RPM means your alt is turning at lower RPM. Like any generator this would give you a voltage drop. Not an expert but thats my...

Budget aint really an issue. Im trying to go big ballin on this build cause Im trying to get this Mag of mine show worthy you know what I mean. I was thinking about going with fosgate amps on this build cause im really trying to do and all RF system. But you think something like 3500 would be...

Yea stock alt... money not an issue so I dont mind going bigger and better. My batts are both in the rear (dodge magnum... stock is already in the rear). What do you mean by how many runs from stock the kinetic? Like how many 1/0 wires? Right now factory mids and highs. That is a project in...

Haha I was trying to avoid saying what amp... Im pushing two t2's with two power acoustik BAMF-2000/D 2000 watt amps. They are rated for 1200 RMS at 1ohm. I know they aint the Sh*t but they are some decent amps. Im sure they have something to do with my feeling underpowered but I know I could...

I think everyone is on the same page... EBAY! Get everything you need on ebay for cheap. You like JL and Fosgate... You can buy something like 2 12's for $250 and get it in a safe transaction. Now thats what Im talking about!

Well I want to get as much out of them as possible. Now im not an expert with audio but I got my stuff together and Im fairly knowledgeable about this stuff. What I got going on right now is the two T2 15s, in a ported MDF box that I built. Like I said, its just under 7 cuft interior volume...

I would just got to home depot and buy some mdf and build a box the size you are looking for. Its not that difficult to put one together. It dont have to be perfect you know... this is your first ghetto set up. If you have to get one of the two subs... as much as I love Fosgate, go with the...

I know there are threads about what song you bump and what you listen to at what hz but I want to know what full ALBUM people are bumping. I mean from track 1 to track whatever it just hits the whole time. Whats your album?

What you mean if I cant afford to lose them? You saying I could probably go more than 1500 watts each but at that point I start running the risk of blowing one up?