Recent content by Jassam

I happily purchaced a Pioneer premier p8mp to replace my stock headunit in a 1999 mustang convertable. I mainly purchaced it because of it's high level voltage output to the amps (as listed 6.5v). It all sounds fine and good, but should I be worried about anything with this HU. I'm sure there is...

I believe I found out what the problem was, the polarity of the speaker wire was not labeled correctly. I spliced a positive with a negatively labeled wire. I also switched the wires to the first set of wire inputs on the LOC. Located on the top left corner instead of the right corner. It just...

Oh, before I forget the wires are set from A5 to A8 which is the top right 4 connectors and the speakers connected are the rear speakers. The RCA is hooked up to the rear output and none of the selectors work (Factory/Common Ground/Lineout)

I have the gains set at around 75% of the way to max. I'm still not sure what it is that is causing it to give me such a low voltage.

yes there are gains on the LOC. I purchaced and returned two of them and still have the same problem. http://www.scosche.com/scosche_caraudio.aspx?CategoryID=36&ItemID=SLC4 Here is the link, hopefully it shows up.

Looking for CDT components 2 sets or 4 speakers in total. PM me the series, condition, and price.

I've been working on my system for hours and I cannot seem to get signal from the line out converter doesn't seem to output a good signal. The gains are turned up 75% of the way and so is my amp. I have the hifonics brutus BX1205D that shows the voltage to the sub being around 14.1 or 200w to...