Recent content by Innovative:Cory

Yes... if you are going to use aftermarket drivers in a factory location, you should add deadner. If not just keep to the factory speakers.

PM sent

Another company that makes very good high output alternators is Motor City Reman. When I owned my 12volt store I would use them instead of all of the "normal" places due to the fact that: a) the untis were more cost effective, b) they build a **** good product, and c) their customer support is...

Check your ground first, if you do not have a good ground the amplifier can be looking for ground along the RCA path. If that doesn't do it, try changing to a different speaker, to see if scratchy-ness continues. If it does continue and you can eliminate the speaker, try changing RCA input by...

I am an SQ competitor...but you could have seen me at Dennis's shows last summer...I was in the Green 300zx twin turbo... I also judged his sq one time for him as well...come to think of it..I also drove my Mitsubishi Eclipse there as well... but yeah I think I remember a kid with an escape. I...

I second the Crank Doctor brand....very underground and very good! I have held the subs in my hands, very good built quality..Very musical, and can get VERY loud! A shop named Innovative Car Audio in Evansville, Indiana sells them already...812-423-7888 and ask for Chase or Brad

PM sent

Anything you do will be more or less just a band-aid. The enclosure is VERY important! But... polyster resin, or anything that you can use to make it as air tight as possible will help. Dowel rods (3/4"-1") will help as well.

PM sent

Fixed....

Bump for some good equipment...

Yeah ...your way can burn a car down.... Im not trying to be a dick here, but doing it halfassed is still halfassed... There are tons of what if's and different scenarios that I could point out that maybe you would understand that the way you said to do it isn't going to work...and be SAFE...

See posts above your last one....

^^^^^^^^^^^^^^DONT DO THIS^^^^^^^^^^^^^^^ Battery is in the same location on both body styles, Z31 and Z32

Z32's and Z31's... go to the passenger floor board, remove carpet, unbolt ecu...there is a grommet you can pass wire into engine compartment right there... Z31's have 6.5"s all the way around Z32's have 4" front, and 6.5" in back with the Bose system... Clarion Active is 6.5"s all the way...