Recent content by Innosentz

That's what i intended to use. I already have some 1/0 wleding cable but only about 15 feet which is not enough to do the ALT to BAT.

Which would be better, two runs of 1/0 or one run of 2/0?

I have a 2007 dodge charger, I currently have upgraded the battery ground and engine block ground to zero awg. However since the battery is in the trunk i haven't gotten around to upgrading the alternator wire to zero awg. there is stock 1 awg ran through the car to the rear battery. If i...

I'm probably going to buy a new one, because $950 plus shipping for a used one comes out to around $1100 so why not the extra $100 at that point?

I am planning on running two 12" xl's, the xlm2's and am looking to run them on a dc 5k or another amp that will put out 4500-5500 watts rms. Preferably around or under $1,000.

Actually if my understanding is correct, if you wire two dvc1's in parallel they will come out at .25 ohms and the amp can not run that

They are dvc1's and I have a sundown 1500D v.2 I know the amp is still good, the subs are working now, I just cant crank up the volume because they're wired at .5 of an ohm and that amp isnt stable at less than 1 ohm

I bought 2 dc level 4 12"s off of my friend a while back, I was told they were dual 1 ohm subs and they were wired to 1 ohm, they worked fine then 1 day the left sub stopped working. a couple days later the other one stopped as well. I took them out of the box and looked at the wiring, and wired...