Recent content by Hurro

/sign

I don't know if this is quoted somewhere or what, but what they mean by that is: The subs will preform similarily in different vehicles using the same box?

Gogo fiberglass!

No problem, hopefully the internet still exists by the time I get around to it to show you. And yea, I've had no complaints about the speakers whatsoever. They get nice and loud.

Dang, I wish I had a work truck and a driveway

So what's the comparison for? Just the wire gauge or quality of wire versus practicality?

OK, I know there will be better low end response if they are boxed but wasn't sure if there was a minimum required. Also forgot: Model is - Clarion SRR6985

Do 6x9's need a specific amount of air in an enclosure? Clearance as well? Should I treat them as smaller subs? (With a few changes of course) I haven't measured it but I'm thinking about making a box with less than a cubic foot of air? Excluding the displacement of the speaker itself.

When you're attempting an install of this magnitude, do you have another car as your daily driver? Or do you use this one? Is this only on weekends? How are you approaching this?

That's a **** fine job under the hood. Nice right angles and everything. Sho-iz-purdy!

See! That's how eager I am to help...too bad I don't know much. :p.

OK, my understanding is as follows: The crossover, when set to say, 400hz as you have it, will not play any frequencies below that line (deeper). The higher it is, the more notes it will let through. If you are using a stereo amp and you have it higher, it will let high enough frequencies...

The crossover cutoff frequency is on your amp, it'll be a dial or digital display if you have a newer amp. It will say "20-20,000 Hz" (dont know exactly what your model will say but it will be in hertz). Tuning your box involves adjusting the length of your port on a ported (vented) box. I...

OK, first and foremost, above all else, etc etc. DO NOT LAUGH! I **** with Photoshop. :-p http://www.tritechservice.com/crude.jpg Barring dimenions, would this be an OK idea for a custom box design, mechanically, that is. How would it sound if I had the subs in the trunk, and the port went...