Recent content by gti303

Rainbow Audio SLC Kicks 6.5 Comps: $165 Shipped OBO Excellent condition. Approx 6 months old...and used lightly for a very short amount of time...I was estimate less than 10 hours... I am selling my car that is why I am selling these. I have a bunch of positive itrader over at...

Alpine CDA-9887 w/ ipod cable: $260 Shipped Rainbow Audio SLC 265 Kicks 6.5 Comps: $200 Shipped Alpine PDX 600.1: $250 Shipped Alpine PDX 600.4: $300 Shipped DLS Iridium 10” Sub $300 Shipped or if you have a 350z, I have a Custom rear corner box I can sell with the sub (much thicker than the...

Bump!!

Just the tweets that came with my SLC265 Kicks

Multimeter

Thanks...GREATLY appreciated!!!

Anyways just setting my gains...just got a question, I'm active on a set of SLC265 comps...whats a good freq for the tweets on this set for x-ver? The manual just tells me to let the woofer chime in at 80hz 12db slope, but not the tweets...any suggestions would be appreciated...right now its on...

Just wondering how much total power you guys putting to your rainbows...I have the 265SLC I will power up in a day or two...but my amp is a PDX 4.150...so since I will be active, I will run 150 to the sub, and 150 to the tweet...obviously I will set my gains very conservatively...but that still...

Bumpkers

Brand New in Box Kicker CVT 10" Shallow Mount Sub 2ohm $85 Kicker CVT 10" Shallow Mount Sub 4ohm $65 Focal Polyglass 165CVX Coaxials $150 All items in great condition and comes with original boxes. Focals and the one used Kicker has about 2 hours of play...I was using the focals as my...

Anyone with a 4.100 wanting some more juice? I have a 4.150 with very VERY minimal usage...but I'm changing it up and am no longer going to power my sub with it, so I don't need that much power going to my mids and tweets...if you have a 4.100 and want to upgrade...and throw in some cash...I was...

actually...looking at this chart...seems like I'm ok... http://www.the12volt.com/wiring/recwirsz.asp

yea I was thinking that...but kind of ghetto...might do it to save a few bucks tho... I have a 4.150 right now...going to grab a 1.600 soon as well

Basically I only had 1 PDX Amp with 4GA wiring...but now I want a second, and I don't want to run wire again...I bought a couple distro blocks for ground and power, but basically they don't fit the 4GA power wire as 'output' I have from knukonceptz...maybe I can fit some 6 gauge or 8 gauge in...

Thanks guys...another ?...my components are rated at like 100RMS and 150max...my amp is 150rms (Comps are SLC265 Kicks and amp is pdx4.150)...with each channel getting 150w...should I aim to set my gains conservatively? or just go all out until distortion/clipping?