Recent content by Got Mudd ?

Anybody Besides Me Watch It ? That Heidi Chick Is Friggin Perfect .

I got one off ebay last week , 215 shipped , arrived exactly in a week , from Fla to Det . The amp looks like new , and works perfect so far . only thing is their communication could of been a little better . overall very happy so far . Hope it works out for you bro .

first off remember you get what you pay for in the world of car stereo . second .. nevermind what the peak power is , always match your amp to the total rms rating of the subs , in your case it is 600watts rms @2ohms . if that is what it calls for then thats what you get . subs are meant to...

BS or fact ? I dont know for sure , dont know what bench you seen ? I was just going by the several bench test results as reported on the ED forum site . one of them recorded 1547 watts @1ohm . at 13.7 volts . true you cant always believe what you read , I think someone here should have one...

the ED 9.1 benched at 1500 watts @1ohm , 13.7 volts , keep your gain down and it will be fine . try it with the stock electrical , should be fine , and always have at least a good battery if you are running an amp .

the answer to all your ?'s is yes . although I would get a larger wattage amp so you are not running your amp at 100% all the time to get the full rms watts . also voltage drop has to be figured in with a stock electrical system . most amps are rated at 14.5 volts or so , normally your stock...

remember you get what you pay for . the audiobahn a8000t would be cheaper and light up .

Then I would get the Phoenix Gold R8.0:1 , Will do 800x1@2ohms And it will light up and sh*t !!

Nope - 2 dvc 2 ohm subs will give you a total load of 2ohms . or .5 which I dont recommend . I believe the comps are 500rms a piece ? which means you need 1000rms@2ohms the A1000DB will not provide that . but ... the A1800DB will give you 1100@2ohms the 1000 would work .. but not idealy ...

two dvc 4ohm subs can either be wired for a 1 ohm or 4ohm load . wiring them to a 1 ohm load would be the better choice . check out the diamond audio d3600.1

you will need a mono amp that does 600 watts at 1 ohm , I believe the mtx does 600 at 2 ohms , so that would not be a good choice , the jl does 500 at 1.5 ohms , so that wouldnt be good either . try to find a jbl 600.1 that would be good or any other that does 600x1@1ohm .

Orion 4002

say hello to my little friend ^^^^^^^^^^^^^ buy it !!

thats a sub with vd

ugggg time for bed