Recent content by gev003

Still available? And would you take a pair of JL W0 10s in trade?

I've been out of the game so I am not familiar with Scan. Is that ScanSpeak? If so what's the model number of the mid and I am looking for something that can get loud but sounds good mellow too. I used to run Adire shiva and tempest subs in past systems so I am not into shiny packages, just...

Be looking for less than 100/pair but would consider any trade offers.

Open to any trades? I have some Onkyo home audio speakers, Polk subs, JVC 5.1 avr, and numerous cable (HDMI, optical digital audio,etc.) Also have linksys router and other misc computer stuff, Sony compact photo printer, Kodak digital camera, etc. Bryan

Looking to buy/trade for a pair of 6.5 mids to replace my DEIs. These will be going in factory locations in front doors of 2012 Nissan Altima. Looking for good value replacement until I can step up to new higher end components. They will be amped with approx 150x2 rms @ 4 ohms. I have home...

pm

Looking to add this pair to work with my Pioneer AVIC X920bt. Used condition is fine. Please email Bryan (gev003@gmail) Thanks

And yes, 34hz is definitely my magic number now.

Ya'll are funny. And yes I agree about the important thing being the install, not necessarily the equipment. And to the first reply, I am far from being on Pioneer's nuts bro. Quite the sophomoric comment coming from an admitted Pioneer owner. I've run Eclipse, Clarion, and Excelon head...

After being out messing around with my new AVIC for the last few hours, Pandora and whatnot, I had to come in to tell somebody about how low and loud my setup gets. Bass Mekanik kills, Bob Marley rocks, and Beethoven sounds unbelievable too!!! For a single 12 getting less than 1k (actually...

The battery is in the trunk and the wire is only about 4-5 feet long. When you say remove the amp, are you saying I need to disconnect the remote and ground and just hook the power wire to the amp?

The ground showed 0-.1 on the DMM... I hooked an ipod to the amp with RCAs and it played for a minute or so with the gains down until it went into protect again. I removed the sub, rcas, and jumped the remote turn on to the power, again it went into protect after a few minutes. Why does it...

Will this be the case even when the sub is completely disconnected from the amp? The cone shouldn't have been moving. I can't wait to get home and test everything else, hopefully its the ground or something simple cause I don't want to hassle with sending it away to Cali again and forking out...

Thanks loop