Recent content by Gene3x

Yea I looked at them.... I am sure they are great. I wanted to get a 2 or three suggestions & make comparisons. They sure are ugly though.

Yea man that is nice. I am not going for anything that radical on the tower. I have a set of Defcon IV's on the tower, which are Image Dynamic speakers. I am pushing 350 a side at 2 ohms. I was looking for some great speakers for inside the cabin which my amp will be a 4 channel at 150RMS...

Is there a Perko switch that will let you run 3 batteries off of it?

Hmmmmm sort of interested but I have already blown my wad on all that I can afford.

I actually do run at 3300 rpm's when pulling somebody because I weight my boat with an extra 3000lbs and have a low pitch on my prop (yes I burn a ton of gas)! But I do chill at Party Cove and run it every so often. Should I see if there is a noticeable difference at speed versus not? Nice...

Sorry it is a Perko switch. An isolater is just automatic right? on board charger it is then.

It is a 90 amp alternater. Indmar says it is running at 40amps when the boat is at idle and 90 on the top end. That should be plenty huh?

If I don't notice a big difference between either setup? Then what can account for the distortion? The speakers? It just gets a little fuzzy when cranked. Real fuzzy with certain songs. I will go check the voltages tommorrow. I also need to address the whine through the speakers with...

That is esentially what I will be running. So with two Stingers and an isolator I should be fine to not have to worry about a HO alternator? I just looked at Indmar's website and my alt runs at 40amps when the boat is at idle and 90 on the top end. That should be plenty huh?

Yea (2 ohms also) it is over kill but I got the amp for cheap so I keep the gain down there also. It is good to have more power than you need so things can run without being under alot of strain right?

Total power able to draw at once? Total RMS? Now: Kicker 850.4 is 215X4 at 2 ohms= 860 RMS & PPI 1500 New setup: Tarantula is 350X2 at 2 ohms= 700RMS, & JBL 75X4 at 4 ohms=300RMS, & PPI 1500 (I probably would not turn the gain all the way up on the Tarantula)

I just got it for $250 plus $30 shipping. So I will now sell my Kicker 850.4, but is adding a third amp going to cause me problems? Thanks Also since the INPUT SENSITIVITY is 0.15 - 12.0V . That should help correct?

This one I am lookijng at on Ebay is about to end: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&ih=007&sspagename=STRK%3AMEBI%3AIT&viewitem=&item=170049943397&rd=1&rd=1 This one also...

Yes that is correct. I have 3 speakers wired in series on the rear two channels and the Defcons on the other two. They are 2 ohm speakers.

Thanks man, I spend alot of time on her and am coming off a broken ankle from a half cab roll so I figured I would do my install while I am down! It has just been awhile since I did any sort of serious install. I will check the voltage and see what size alt is on there. Is there anything else...