Recent content by fusi0nhq

I am fixing to install a system in a 2000 expedition for a friend. He has enough money to put down a pretty **** good sounding system. Anyone want to give me ideas and good places to buy the equipment? We're looking at a 2- 15" setup (more than likely Brahmas) For mids/highs we're looking at...

Hey i need someone that has installed a monitor in the AC climate control area to help me out and let me know what is involved in moving them! Thanks for your help anyone!

I will be wiring the two 8 ohms together, and then the two 4 ohms together to seperate amps so that won't be a problem. I just want to make sure before i buy these suckers!

That's what I thought, as long as they are both wired to..lets say 4 ohms, they should be ok. It'll be two different amps. Anyone else?

Is it ok to mix different Ohm subs if two are single 8 ohm and 2 are single 4 ohm as long as i have them wired to two seperate amps running both at the same load? Just a question because i can't find two more of the speakers I Really want. Thanks!

Yeah, i was hoping it wouldn't be too hard. I am wondering if anyone has done this with a jeep and if it's unreasonable? just hit me up thkns!

Anyone?? ^^

IT's a IVA-C801**

I want to put a Alpine IVA-C801 into the dash of a jeep grand cherokee. The only problem is that I have a overhang that would block the screen from going up. I have thought about moving the Climate Control to the upper part (where the head unit is now) and putting the Monitor in the place of...

I have a problem with my Viper ESP. My passenger rear window only rolls half way up when the alarm is armed. Also my rear windows are backwards (up rolls down and down rolls up) Is this something I can fix or is it something that needs to be taken back to the shop?

mine did the same thing and i checked my hood pin and that was the problem. Make sure your hood pin is being pushed all the way in. Mine was being stopped by the rubber wet seal around the hood. Just check it.

Ok. Well can someone tell me dimensions of box and ports?

what about if it's sealed. I don't know a lot about these drivers, so im open to suggestions! I just want it to quake!

well let's say i wanna send 2400 watts total and port them. What amp would you suggest? I want some good amp that'll last and i won't have problems with. Thanks!

I am going to buy 2 12" brahmas and need an amp. What would be a good amp to pound the hell out of my truck? I will probably go sealed unless anyone has another opinion!