Recent content by Evyn1

When the model can get port calculations correct. I’m not going near human advice. Human advice is dictatorial, tyrannical, and not constructive. I don’t care about your advice!!! You can still install it through.

I listened to the AI model regarding my 5 inch slot port. I didn’t listen to people. I didn’t read anything you all posted and it works incredible!

Only a matter of time till a model can do everything better than a human. Every time I ask the model how it will sound it’s been accurate. Since it said the trunk will sound good as a bandpass I’m sure it will in reality. That’s great because I’m done with human advice!

For: 6” round port. 33 hz. 7.8 cubic feet. I got required length 14“.

GPT: “General Rule for Doubling Ports: In general, if you double the number of identical ports, the length of each port can be reduced by approximately half to maintain the same tuning frequency. But this is true only when ports are identical in size and function (same diameter, same tuning...

ChatGPT told me if the two ports connecting the cabin to the trunk are the same frequency then it’s considered a 4th order bandpass. If the tuning frequency of the port though is higher frequency than the 33HZ slot enclosure within the trunk. Then it is a 6th order bandpass.

There are two 6.5” speaker mounts on rear deck. I want to add (2) 6” ports to connect the truck into the cabin. The Total cubic feet after enclosure displacement is 7.8 cubic feet. I know for a fact that (1) 6” port to tune it to 33HZ is 4.6”. Anyone able to calculate: (2) 6” Ports...

The enclosure sounds good! The bass needs metering! The Zcon throws SPL in this enclosure! 3.5 cubes after displacement. 33HZ. 60. Square inches of port area. ChatGPT has good advice but currently lacks accurate port calculations!

Can’t wait till AI generates beyond every retard! So they can’t waste our time! Recommendations: ✅ For More SPL: Increase port width slightly (~6” to 6.5”) to reach 70-75 in². ✅ For Balanced SQL/SPL: Keep the 5” width (60 in²) or slightly decrease to 4.5” (54 in²) for cleaner sound. ✅ Check...

How come when I explain the same to ChatGPT it can understand my question? I literally posted this thread here’s the answer I was looking for: Recommendations: ✅ For More SPL: Increase port width slightly (~6” to 6.5”) to reach 70-75 in². ✅ For Balanced SQL/SPL: Keep the 5” width (60 in²) or...

I’ll just post a video of it throwing some SPl on YouTube. I have a slot calculator so I know it’s 33 HZ! Funny how no one focuses on the question.. just everything else until I explain it to their ego. Everyone haha please believe my basic enclosure is the right numbers! Please