Recent content by eletromagnetica

ok thats it i need to run another rca set to the amp and put the crossover on that line. thanks

but if the crossover is before the amp wont it effect my speakers as well? I'm missing something. i've got one left and one right channel going to the amp then to my front speakers and sub.

polk pa500.4 polkaudio.com/products/pa500_4

what can i put between the amp and sub that will have the sub putting out only lows? a volume adjust would be nice but not necessary

ok it's a 4channel amp. so can I bridge the sub to the rear channel then to a crossover?

Amplifier Power Specs RMS Power at 14.4V Watts per channel NOT bridged @ 1 kHz 4 ohms 90 watts 2 ohms 125 watts Watts per channel bridged 4 ohms 250 watts Dynamic Power at 14.4V Watts per channel NOT bridged @ 1 kHz 2 ohms 200 watts

it seems to be bridgeable and its worked so far but the sub sounds terrible cause its putting out highs. do i just need a crossover?

I've got my speakers/tweets and the sub hooked up straight to my amp. the sub is hooked to left-side-positive and right-side-negative cause it worked. its a polk marine series that i put in my fd rx7. I decided to add a sub but there is no sub channel on the amp. What would be the best way to...