Recent content by Ebbsnflows

This is probably a dumb-*** question (I'm an enclosure newbie)...but where do you get the Rings? Are those home-made? Or can you buy them?

DOH! I figured out my problem. I was chasing the wrong path. My deck has 3 outputs (Front, Rear, seperate Subwoofer). Up until recently I had been using the Fosgate amp to power my Sub. When I installed the components up front, I just unhooked the Sub wires, and ran the components to it in...

The supplied MBq x-overs are passive...there are no external switches/adjustments. Based on that, I have no idea what "mode" they're in.

Yes, both sides behave identically (I initially thought the crossover was bad too). So while its entirely possible that both are bad...it's not likely. Fox- I don't have a multi-meter, so I'm not able to say. I'll see if I can borrow one from my buddy. I have a new amp arriving today by...

Ok, I messed around with them again this afternoon. I changed the crossover setting from -6 db to 0 db (for the tweeter). After that, I cranked the volume up to about 30 (with the factory component speakers I never went beyond 20 because it became painfully loud)....anyway, with deck at 30...

Thanks for the link But I'm still confused as to why MBQ would use a 6 ohm tweeter? Why not stick w/ 4 ohms for both the driver and the tweeter?

Hi all- I have a question that is busting my brain. I recently ordered a set of MB Quart DUA 216's (6.5" component system) from OnlineCarStereo.com for my 00' 4Runner. As I was installing them, I realized that the driver is a 4 ohm speaker (as it should be), however the 1" Tweeter is rated at...