Recent content by dyohn

http://store.hlabs.com/pk4/store.pl?section=12

Looks like your amp will handle a 1-ohm load. Wire all four voice coils in parallel. Be sure you set your gain properly.

You probably have the PCE216? Look at your owner's manual, page 5.

What kind of subs are they? SVC? DVC? 2-ohms, 4-ohms, 8-ohms? And I've never heard of Audiokraftwerk but what load impedance will it support?

1: yes. 2: no.

Hey, Mike Vick needs work...

I use the exact same center channel.

I agree, it's either a low voltage problem (what is your voltage level when this happens?) or the amp gain is too high, or one of your speakers is dying. Parts Express (Dayton) subs tend to have a somewhat short life span if you push them too hard (voice coils will separate from the former...

The "best" ground is usually to drill a new hole through the bottom of the trunk (being sure to NOT drill into the gas tank) grind off all the paint and install a new 3/8" bolt with star washers to create a ground point within 18" of your amps. Then be sure to meter it and if it's greater than...

Have you checked your ground return resistance? Should be less than one ohm. Also, it could simply be you have a defective subwoofer amp.

Sounds like you either have a really bad ground on your sub amp and/or your gain is cranked way too high. Make sure your ground return resistance is less than one ohm, and set your gain properly (there is an excellent sticky about doing this on this forum.)

When I was a NOOB my dream system was a Pioneer Supertuner under dash combo FM tuner 8-track player and Realistic 6X9's to add to my factory AM radio.

bigchevyboy, contact Ohio Generator and get a quote for your vehicle. Best HO alts I have ever used. http://www.ohiogen.com/html/contact_us.html

A higher amperage fuse will not provide "better efficiency." As stated above, NEVER replace a fuse with a larger one because it is blowing. Indeed, I say never replace a blown fuse at all until you know why it blew in the first place. Fuses are all that stands between you and an electrical...

Wow. There are so many things wrong with this post... hey, if you can figure out how to make electrons "slow to a crawl" then let's patent it and be the first to prove Einstein wrong, OK? We'll be ba-f**king-zillion-aires. And we can sell those high-flowing wasted energy whirlpools to the...