Recent content by Dr. Dan

I called Pioneer support and the tech said that the crossovers in network mode DO effect the amplified channels. So I ordered the deck and will confirm this when I install it.

I had asked this in another thread, but didn't receive an answer. Anybody know if the crossovers in Network mode effect the the amplified channels , or only the pre-outs? - Thanks

Nobody knows? I downloaded the manual, but can't find anything about the amplified channels. This would also be important if you wanted to run a 4 way active setup with an additional external crossover run off a full range amplified channel.

Do the 880PRS crossovers in Network mode effect both the pre outs and the internal amp outs or are the amplified channels always full range? I'm considering some very low wattage tweeters and would love to not have to buy/mount another amp.

My power antenna is starting to drive me nuts. I'm fed up with the sound of the thing constantly going up and down as I'm working on my system. I like the clean look with it down, and I imagine the radio reception is generally better with a longer antenna, but I'm tempted to try a non-powered...

I heard about a number of reliability issues with the CD400, which I was about to buy and then chickened out after hearing the stories. But I was under the impression that the CD300 and CD500 were the replacements for that unit and the reliability issues were addressed, but that's just hearsay...

If your not running active, then how about the Nakamichi CD500? All Amber lighting(+ other colors), 24 bit D/A, Mp3, 3 sets of pre outs. Might run a little high for your budget....I think around $500.

I recently installed a Refurb Clarion DXZ555MP in my girlfriends car. Paid $102 shipped from Ikesound on Ebay. It arrived quick and looked brand new. Anyway, the unit sounds great, rich and powerful beyond my expectations. I think it sounds better than many units costing 3 times as much. Has...

Lookin' Good! I have an MX-6 that came stock with 6x8 door speakers (thanks a lot Ford!). Does the 626 have 6.5 openings stock? The one comment I might have would be to try and find the plastic trim pieces around the door handle, door pocket/pull cup and/or the woofer grill in black to match...

Yes, that's correct. I think that headunits/EQs will only put out their maximum voltage when their respective volume controlls are at or near maximum. So an amp with a slightly lower input rating should be fine as long as you don't max out the gain on the EQ. Clarion sound and build quality...

Ever-Stick Stay-Put Quickstick Second Skin Birth Mark (never comes off) New Skin Spray Skin Bond (007) SS Bond-All Sure-Bond NeverFail Unifier Adhere-all H.R. Damp 'n' Stuck Damplistick Black Label Pro Adhere

Allright...F me for being out of the loop...But the Devil needs all the press he can get so screw it

Most users ever online was 666, 02-22-2006 at 08:57 PM. 3 days ago there was 666 users on this forum...Based on that number I think I'm in the right place

Anyone run an active setup with your headunit powering your tweeters? Is this even possible, perhaps with with one of the higher end Eclipse decks (8445/55)? It would be really nice not to have to buy another amp and since many tweets really don't need very high power.... ya see where I'm...

I don't see too many posts on this forum about DVD decks like that, so don't take it personally. Most people here seem to care more about time alignment, EQ, preamp voltage, and crossovers in their headunits. Sorry, I can't help you with your questions either, but generally speaking I think...