Recent content by ditosdad

Awesome, I will look into that!

Well I pulled the trigger based off your recommendation. I went with the JBL P660c in the fronts (factory already has a spot to mount the tweeters on the top of the dash), JBL P662s for the sound bar and the JBL GTO804EZ amp. Thanks again!

I guess one more question to that set up. I wanted to keep the power close to the rated RMS power on the speakers. Is that amp a good choice based on the power?

That sounds good then! I thought running in 2 ohms was bridging that amp.

Looking at the JBL P660C speakers and the JBL GTO804EZ amp. The reason why asked the question is that, I would think running in a non-bridge mode would be better for the amp long-term. I could be wrong?

The speakers (not subwoofer) I am looking at are 2 ohm. Can I wire an amp to run the speakers in 4 ohms or do I need to bridge the amp to 2 ohms?

Good info! I checked out the jbl's and they look good! I'll take that advice and scrap the kickers. Should I look into the jbl amps too? If so which one would be better with the JBL P660C, GTO 804EZ or GTO 504EZ? Also I was thinking the JBL P662s coaxial in the rear over head sound bar.

Right now I really don't have room for a sub. I cannot put a sub under the rear seats because I need the rear seat fold down feature. I really don't have room in the trunk area because I have a 110 pound German Shepherd that likes to ride in the back. I can get 2 sets of Kicker 40cs654 for...

First, I used to be big into car audio back in the 90's, and have only been comparing factory sound systems since then! I had a 2010 Wrangler Unlimited Rubicon with the factory upgraded Infinity sound system with the 8" subwoofer. That was not a bad sounding set up for a factory upgrade. I...