Recent content by dgreen2321

Yeah, definently look on eBay. My friend's brother stole a ton of watches from the watch shop he worked at, then put them up on eBay. The owner looked for them on eBay and guess what he found......

Does it get unbearably loud? What amp are you using? Don't get me wrong, my RSD's don't sound terrible to me, but not nearly as good as I thought. They get somewhat loud, but not even close to unbearably loud without distortion.

So today I tried to EQ it a little better and took the advice of the poster in this thread who told me to EQ under from Flat. Sounds better, but I still think I'm not getting the most out of them.

Anyone else?

I blew out my 10" Kicker CVR today, so now I'm looking for another subwoofer around the $150 range. It will be powered by a Blaupunkt amp at 400w RMS. Any recommendations?

So I took the door panels out again and played around with the settings and phase of the RSD's. Nothing improved really. I don't know what it is or what to do. Maybe I'm expecting too much I don't know. I was just expecting more from these speakers that everyone's been going crazy over. The...

Red.

Does anyone know what wire from the tweeter is negative? I looked in the manual and it says nothing. I'm guessing the one that is a mixture of black/red is? Am I correct or no?

On my amp there's only one knob for the crossover setting.

Alright, I'm confused. The only setting on my crossover which I can change is the tweeter from 0dB or +2dB. You mentioned that there's a gain setting on crossovers but mine doesn't have one (or not that I know of) or any settings for that matter.

How loud can you crank them up to without distortion? To the point where it's a little uncomfortable? And by the way, thanks for the help everyone. I have some ideas of what to do and change now. Looks like I'll be taking the door panels off again (such a pain to put back on).

Yeah, I've had to of mess something up, but I just can't figure out what. Maybe I just need sound deadening. So you think deadening will make a big improvement in sound quality and the loudness of the speakers? I have no idea how to install it and I want to make sure it's done right so I'm going...

Yeah, I've heard deadening helps a lot, but in this case, I don't think that lack of it is the problem. I think it's the speakers or something I did wrong. I can just tell that the quality is bad. I don't know, I'm probably wrong here but this is just the way it sounds to me. Wish I had a friend...

No, my doors aren't deadend, but the road noise on the car isn't that bad in the first place and I don't drive on the highway that much. The tweeters are mounted were the stock tweeters were mounted, in the first pillar in the front of the car pointing at me. As for polarity. The PDX's speaker...

I have Loudness on Mid and I usually put the EQ on the custom setup I created or Powerful. I have tried normal CD's also.