Recent content by dflillemae

Yes, I found a temporary solution. Thanks!

If i take the other end of the remote and connect it to the wire that's supposed to be the ignition for HU, the amp turns on. I think the problem lies somewhere in the HU.

All the fuses are OK, I have a fully functional and working sub amp, so i switched all the power, remote and ground wires from that amp onto the GTA4 and still the same story. I guess that eliminates the chance of wiring problems? I don't think it's the remote wire because taking the rem from...

Hey, I had a car amplifier playing at a room for a while and having a jumper from +12v to remote to power it. Today, I moved the amp back into the car (it used to work there aswell) and i get no power. It's a Blaupunkt GTA4 amp. I tried using the remote wire from my sub amp but still no power...

Alright, it appears the subwoofer which is connected to another amp seems to start crackling with the rear deck speakers aswell. But not when ONLY sub RCA-s are connected to the HU.

I'm not sure what i should do now... I've tried pretty much everything i have come up with It's still strange that the speaker works fine if i put the rca only to channel 1 and 2 but putting the very same RCA set to 3&4 makes the speakers go crazy. Do you know a good ground spot for Audi...

The amp is brand new. Running the RCA-s straight to amp still makes no difference. I just discovered that every time some lower frequencies play in a song, the power led of the amp dims and some weird frizzy sound comes from inside the amplifier and the rear speakers crackle and when increasing...

Alright. I checked all the RCA connections. It seems like my amplifier rejects sending signal to 2 speakers at once. As stated earlier, i used a Y cable to split 1 set of RCA-s into 2 behind the HU (1 leads to sub amp and another to the GTA4, where i use another set of 'Y ' to use all 4...

At the moment it's not mounted anywhere till i get this problem sorted out. Nah, it only has HPF and LPF

I tried running 2 channels without bridged mode and 1 set of RCA-s straight from the HU to amplifier and the problem is still there.

Hello, I just bought a pair of new speakers (GAS Silver GS620P) and amplifier (Blaupunkt GTA4). After installing the speakers and amp to the rear deck i tested them out and i got some loud crackling noise whenever i turn the volume up to about 50% on the HU (kenwood kdc-w3041). The front door...