Recent content by DeathGrind

hey guys. One more question. The kenwood amp calls for a 4 gauge wiring kit, which I have already purchased. I was looking into getting a fused power block. Since I have already ordered a 4 gauge wiring kit, is it safe to use a power block to run a 4 gauge input wire, and then split it into...

I have a PPI A404 and a PPI a300.2. I have read some good things about the PPI a404, so I think I will use that for my front and rear speakers. I'm having trouble finding some good 6.5" (front speakers) and 4" (rear speakers). The PPI A404 rates as the following: Art Series Model: A404...

Well I ended up buying the KENWOOD KAC-9104D . Got it for around $130.00. It is rated at 2 ohms: 900 watts RMS x 1 chan. So that should be good enough to power my subs. I found out that the other PPI amp i had was the PPI A300.2. Not sure what I'll use that for.

thanks for the info! I was looking for the suggested amps, and can't seem to find them. Anyway, I don't really have much money to spend on an amp now. Most of my money went to the subs and my deck (Pioneer Premeire DEH610BT). I could maybe spend up to 150 dollars on an amp. I not picky at...

Hello Everyone! I need some advice for powering my subs. I just purchased a JL Audio CS210RG-W3v3-2. Technical Specification * Sensitivity: 85 dB * RMS Power Range : 200 - 1000 Watts * Peak Power Handling: 2000 Watts * Impedance: 2 Ohm * Low Frequency response: 25 Hz * High Frequency...