Recent content by Dan-NEP

Thank you very much. I appreciate the reply. I will write more in more detail a bit later, but from what I am hearing I am certainly thinking of a lower impedance for the next production run. I have seen enough during laboratory testing to believe that 4 ohms usually sounds better, but this is...

Our 400W version, which will retail for $249.99, can handle the same power, up to 750W RMS, and will compete directly with the Sundown SA 12". The Sundown SA subwoofer also has a 2.5 inch coil. We will introduce more coil options in the future. Ours will have better sound quality and play louder...

The eBay listing you are linking to was a 1 time no reserve auction done as a promotion. They cost more than that to make. The normal price should be $399.99, and they are currently on sale. If it says $499.99 for the normal price than that was a typo. Sent from my VS990 using Tapatalk

The 750W subwoofers are still on our product introduction sale, check out our web site, Amazon, or eBay. http://www.newenglandprovidore.com http://www.amazon.com/dp/B01M2XKLC6 http://www.ebay.com/itm/332001287743 Sent from my VS990 using Tapatalk

I designed them to work best in a 2.25 cubic foot vented enclosure tuned to 32Hz. They sound like they are in a sealed box, but play much lower. It's hard to tell that it is vented, and the lack of mechanical noise during excursion helps a lot too. Sealed is great as well but you will need some...

To answer the questions about our coil design. The coil was designed to minimize inductance. If you look at our 750W version, it has a 2.5" single 4 ohm coil with a 20mm Xmax. It has an inductance of 1.55mH. That is incredibly low! In combination with the two shorting rings inside the motor...

I signed up as a Supporting Vendor to ease any conflict of interest here.

Hello everyone, my name is Dan and New England Providore is my company. I saw the posts about my subwoofer so I thought I would stop by and say hi. I will certainly not try and sell anything here, but I thought it might be fun to discuss subwoofer design since questions were asked about a few...