Recent content by DaDunc205x

im not 100% on strappability, lol. but my only concern is that one amp, although the same, may be slightly more powerful.

im going to run two(the same) 2ch amps to one dvc(4+4) sub. my guestion is, can i wire each amp to each coil (i.e. amp one to one set of terminals, and amp 2 to the other set) or should i run both sets of wires to one connection, and run that connection in parallel/series to the subwoofer? thanks

Which antenna adaptor do i need for a 1996 BMW 328is. It has the factory 10 speaker system with the factory amp, if that matters at all. and i believe the antenna in in the back window.

how much are the type R's and where did you get them? i've been looking for some but they are expensive around here.

im looking for a box w/ more spl than sq. Slot ported, but im not sure what Hz to tune it to. Daily driver w/ 600 rms. approximate size per sub would be great so i can build a box before my sub arrives. what has worked well for some of you?

you are looking at the wrong #'s on the amps. Im assuming you have 10" L7's, and their rms is 600. The amp you want should have an rms around the rms of the sub. the RF amps you want to get only put out 200 watts rms (1/3 of what you want) however the maximum output of the amp is 600 watts...

nope not a seXXX, just the SE

Ok, I have a 2ch amp bridged w/ 600 rms at 4ohms. I've gotten down to the L5 and SE 12's. Both rms around 600 and max about double that. Price for both are around $140 +- ten bucks. however, i hear RE no longer makes the SE's in dual 2 (and they wont even for the $25) How is the SQ/SPL on...

12 comp vr: $100, only 400rms 12 L5: $same as SE($160-170), 600rms 12 L7: too expensive L5 seems like the closest match. now the question is L5 vs. SE

ya, i thought they might, but i wasnt sure. when i ordered my SX a few months ago i remember they asking what configuation i wanted.

I already have a hifonics zeus zx6000. which is a 2 ch that is 600 x 1 rms @4 ohms when bridged. I was set on the resonant engineering SE, but its a dual 4 ohm. I dont want to run the amp lower than 4 ohms, and at 8 ohms it wouldnt be putting out enough power, so...... i need to find a...

Why cant i seem to find many 600 rms rubs that will run at 4 ohms? all i seem to see is dual 4 ohm. I need a dual 2 or single 4. How much does RE charge to make the dual 4 into dual 2? or should i look at audiobahn or PG or another brand?

im looking for a cheap $30 sub that i can neglect. its going in next to the engine compartment in a boat, so SQ doesnt really matter. I will be getting th SE, but not for a month or two. And i already have the amp, so i just want some bass to help fill the system

what is the least expensive 600 watt sub (RMS) you guys know of on ebay or ikesound or any of those places. Im just looking for a cheap one for the time being before i get my SE

OK, i'll try and clear it up. I currently have in my truck: jbl1200.1 & SX12 I currently have in my boat: hifonics zx6000 600rms & (NO SUB) Im just looking for a sub for my boat, and i dont really have much room for 2. And i dont want to underpower another SX, or spend the money for...