Recent content by D_ALPINE_M

Looking to design a box for my 99 gmc yukon. The subs I have are both Diamond Audio D9 15" dvc 4ohm. I will be powering it with a Diamond Audio d5 1200.1 mono amp rms at 1400-1600 watts at 1 ohm so I will be wiring it down to 1 ohm. Currently I am running one at 32hz slot ported in a 3.5cuft box...

Looking good. I had to remove my front pass seat and rear bottoms to run my wires. That was not too bad. Keep the pictures rolling!

Very nice box build. Is there any software online to calculate the aeroports that need to be used? Sorry for the newb question. I just recently built my slot ported box for my 15 and was wanting to do another setup. Thanks in advance, Jay

Did you ever get to this?

pm sent

Your box width would be okay at 45 inches wide. Now your height should be at 15 and the depth at 14.5. Now your port opening should be 3 and the port length should be at 26. All the sizes are in inches and this should bring you at your desired tune of 25hz. The site below will give you an idea...

That is a good amp. I currently have the MRP-850 and it does a good job!

Looks good, very strong glare from the sun.

Looking good so far just not into the rims on last pic. I'm sure he will upgrade keep the photos coming.

Looks good!

We have hot chick at my gym through out the day. I normally go around 6pm and boy are there any! I hit the gym at least 2 hours 4 times a week. Motivations come from the hot girls being there ha ha. Anyhow I feel that anyone sitting around or working out there jaw should just go home and be on...

I may have one for you brother depending on the plug type he has. Does he have a phone jack type or network jack type?

Got the box built and running it with my 800 watts mono block amp. Sounds real good. I am going to run the wires for my 1200 watt amp this weekend. Need to get an amp rack built for it also. Pictures will follow.

hello

Welcome aboard!