Recent content by Chickenmilk98

A new remote wire ran and tried off two sources only one of the amps turned on the other one won't. It has power at both the remote post and the power post but will not turn on. Still turns on if I run a jumper lead but the relay wouldn't work when wired up.

A remote lead from the headunit will not turn these amps on as they power from the deep cycle is a lithuim battery and creates a voltage difference. I've ran 3 remote wires to test all have voltage and they cannot turn the amp on, unless its from the same power source as the main power wire...

So if i had a realy that has main power from the Deep cycle ( Lithuim ) remote wire from headunit (AGM) and than ground and than a wire going to my amps that would than work ? For reference i have a deep cycle Lithuim in the rear that powers all my sound systems and ect but it has no...

So that amp fires up when you split that power lead into the remote and power. But it won't work if that remote comes from the start battery and the main power on the 2nd. In short both the remote and main power have to be on the same battery or it doesn't power up. Seems silly but that what is...

already ran a new wire from the headunit remote to the amp and gets 12v at the both ends but amp wont turn on

My speaker amp will not turn on unless both the trigger wire and main power both come from the same battery. It was running power from a deep cycle and a trigger from the headunit but that will not turn it on. It will only power up if it has constant power from the same source as the main power...