Recent content by cfp

Sorry i guess that i wasnt very clear; these 3 values are from the amp user manual nominal output power (B+=14.4V) 2x80W/1x210W on 4Ohm nominal output power (B+=14.4V) 2x112W on 2Ohm loudspeaker impedance (stereo) 2-8Ohm and the speakers are 60W RMS with an impedance 4Ohm each The amp...

Am i missing something my speakers are 4 ohms, or are they 8 ohms because they are wired in parallel?

Thanks for your reply, mono isnt a problem, im just looking for a fix until i can afford to buy myself a new one. There are no seperate controls for each channel. So would i go about this by putting both speakers into the same output on the amp? Also how would i go about setting the correct...

I've just installed an old amp for my front speakers and one of the channels is fuzzy/crackly but the other is fine, it is also fine in the bridge mode. Have tested the amp with another speaker and it does the same thing. So assuming that its the amp that is broken would it be possible to wire...

My speakers are fixed to the door using rivets, what is the cheapest way to attach new speakers to the door?

ok will try that, many thanks for your help.

Are thee better?

Here are a couple of images, it appears that the middle part of the dash is attached to the other side, and the bottom bit covers the entire centre console between the seats.

Its a 2000 Toyota Avensis

I was trying to remove my head unit the other day using the keys that were in the car when i bought it wouldnt work so I took the bit off behind the face plate and it appears that the head unit has been screwed in to something and the screws are at 90 degree angles. Has anyone come across this...