Recent content by casmc

Nevermind, I am getting the RE SX-12 and using the box calculator on their site to build my own box. Thx

Anyone else know much about MMATS? Seems like a lot of people are fans of RE's, ut I can't find opinions on MMATS (not many at least).

No, I could go with a 3cuft. Recommended was 2.0 though for the MMATS. You think 3cuft is better?

I'll run one of these off a MMATS D1500.2 amp. Which would you say would be better in a 2cuft ported box?

Speaker is MMATS P3.0 12" powered by MMATS D1500.2. Box is 15"x14.5"x30"; port is rectangle 2" by 29.5", making a right turn after 11" deep. This is from sticky: Free ox Plan section. Is this going to work, or should I say sound good?? Speaker specs are: Voice Coil (Ohms) 2 x 4 Fs (Hz.)...

HA. I looked at the last one, but not the first. Thx.. I'll look elsewhere I guess.

I need a typical rectancular shaped box, but need these specs to be followed. Going in an Escalade. Box needs to be 2.15 cu. ft. internal volume, Port needs to be 20 square inches by 13 inches long. More info on speaker is: Fs (Hz.) 26 Vas (Liters) 84.0 Qts .18 SPL (1W/1M) 92db Power...

Newbie to this forum, and wanted to say whats up. I just posted a thread in hopes of getting some help with box design (typical newbie question). If you wanted to check it out and give some advice, that would be sweet. Need to build a box for a MMATS P3.0 12". Pre-Fabs dont seem close enough...

Can anyone help me out by giving me the box specs for an MMATS p3.0 12" sub? Call me dumb, but no matter what calculator I use, I never get it right. I've looked on this forum for designs and came up with the attached from Sticky's free box designs, but I am not sure it is ideal for the...