Recent content by Casey K

Okay, I rewired the subs, but the amp was still overheating. I bought a small car fan and hooked it up in my trunk, and I haven't had any problems with overheating since. Of course, it's been a little cooler lately so maybe that's all it is. The amp is grounded straight back to the negative of...

Like that? Would I bridge the channels or no?

Eh, each speaker is wired to a separate channel. Maybe I'm misunderstanding you. Is there diagram of how it should be wired? EDIT: That's how I have the subs wired with one going to one channel on the amp and the other sub going to the other channel.

I bought a Profile AP1200 back in September, so this is the first summer I've had it, and the thing has started to go into protect mode from, I believe, overheating. It's hooked up, in parallel, to two Pioneer Premier TS-W1007D4s, by the way. Are these amps known to overheat? I want to add a...

What would be a recommended volume level on a Pioneer DEH-P3900MP for setting the gain? For that matter, what would you guys recommend I set the bass levels and such at?

I had pretty much the same problem. I replaced the RCAs and everything worked for awhile, but the new pair has also gone bad. I have a strong feeling that it's my Pioneer HU that is frying the RCA cable, but I'm not sure. Is that even possible? If the RCA terminals are the problem, could that...

How do you do this if the crossover is permanently set?

I recently bought an 03 Kia Optima, and I replaced the factory stereo unit with a Pioneer DEH-P3900MP. I had everything hooked up and it sounded great except for the radio. I realized that the problem was that I forgot to connect the power antenna wire. The HU harness doesn't have a power...