Recent content by caraudionow

To get a four ohm load with three subs you'll need to run a 12ohm woofer or three D6 subs like JLW6's.

Why did you buy an amp that runs at 4ohm mono when you have a 4ohm DVC sub? Honestly your best bet would have been to buy a mono channel amplifier, possibly a class D, which would have had more power and even been cheaper. They are also perfect for 2ohm loads.

The whole issue should be taken up with the installer. The dealer did not make the item, install it, wire the system, or even get to see how they did it. The installer wired a sub to an amp at 1ohm which should never be taken below 2ohm. Why push its' limits when all you get is a burnt amp or...

Kicker states that the subwoofers will handle 1000 watts RMS however running a BD1000.1 would push far more than 1000 watts into a 1ohm load. Why would you run a BD1000.1 at 1ohm. They are made to be run at 2ohm. A burnt voice coil is the result of overpowering the subwoofer in which the coil...