Recent content by CanIBDom

  1. C

    Quick midbass question

    Thanks for the input! I should have added that my only goal is to make my rock and alternative music sound good inside the vehicle. I'm not trying to wake the neighbors or entertain people at red lights, so it sounds like I'm after the clarity of round comps.
  2. C

    Quick midbass question

    I'm soon going to replace the Pioneer 4x6s in my front deck with 80-100w RMS components. I can fit both 5.25s and 5x7s up in there...would 5x7s provide significantly better midbass than the other? (My bass will be coming from a 12" at around 150-200w) I'm wondering if there is a general answer...
  3. C

    Sub setup for a minivan

    Thanks for the suggestion. Any others?
  4. C

    Sub setup for a minivan

    I only listen to rock and alternative, and I'm not looking to shake the neighbors as I drive down the street. I just want the music to sound good inside. Considering this info, would a 200-300 RMS amp driving two 10s or 12s be a bad idea? Would 150-200w RMS into a single 10" or 12" work better...
  5. C

    stereo panel mounting clip

    Can anyone advise me on where to get a replacement retaining clip for the mounting panel of my 2000 Ford Taurus? Thanks in advance!
  6. C

    Wtf is going on?

    +1. Exact same thing happened to my brother. He drove home from work and the lights started dimming as he pulled onto our street. Parked the car in the driveway, tried to start it up again a minute later and it was dead. Jumping the battery didn't give it enough juice to pull out of the...
  7. C

    Big 3 + Existing Wiring

    Reading the How to select the proper fuse size thread seems to clear things up for me. Thanks again for all the replies!
  8. C

    Big 3 + Existing Wiring

    I've read that you should fuse the wire to its amp capacity on several websites. Here's one I have bookmarked: http://www.the12volt.com/info/recwirsz.asp
  9. C

    Big 3 + Existing Wiring

    Thanks for the quick replies! Looks like I'll be getting the 1/0 and ring terminals this week. I think the only question I still have is where to buy a 350 amp fuse and fuse holder. Does anyone have any suggestions?
  10. C

    Big 3 + Existing Wiring

    Hi all. After a couple weeks of observing I'm ready to participate in these forums. I recently installed a Profile AP1040 in my 2000 Ford Taurus with the recommended 4 ga. power and ground wire. Now the headlights dim when I use the power windows and the amp ocassionally 'fizzles' (for lack of...
Top