Recent content by broski31

there is wiring. The original harness was cut and just straight wired to the factory stuff.I tried hooking it back up the same way it was taken out and i got that problem. they really did a shitty job. most wires are cut short, and only 2 speakers were hooked up.

He said it was fine in another car

Just buy a lock for the doors. They sell those at pretty much any auto part place.

Too far a drive for something that should be easy. I felt all over inside the dash, no factory harness. Looks like it may have been done by someone who was too cheap to buy the harness. I still need the book for my car. I havent done much to it due to the snow and cold. Again, I need to get...

I've installed a few radios to know enough how to hook one up. But I have run into an issue with the one I am trying to install now. I just purchased another ride and the person that had it before me had a JVC hooked to a disc changer in there. That radio kept going on and off whether you hit a...

The Autotek does 1500@2 but the Kicker more than likely does a iittle more than 1500@2.

are your Rs 2 or 4 ohm? I would go with the Autotek because I owned it and it is stable down to 1 ohm.

Depending on the kit it should come with one.

Where did you score that router? It looks nice. I might pick me one up to mess up a few pieces of MDF.

Even the attempted save is not that good. This thread needs a lot of help.

Even your pic of Jeep Brah can't save this.

I LOL'd

No, it's slang for "brother" or friend.