Recent content by Breogan24

Guys need a little help here, I want to set my gains w/ my oscilloscope. I have a 50x4 amp that is used to Bi-amp a set of MbQuart RCE-216. So each mid gets 50w and each tweeter gets 50w as well. The included x-overs cross the tweeters at 4200hz, I have an Autosound2000 amplifier setting cd w/...

That is actually a device to detect the road noise while driving, so according to how you set it up, it is supposed to automatically increase the volume as the ride gets noisier.

I sent u PM

Why not Bi-amp your front components to the 450 amp (this was you send 50watts to each tweeter and each mid speaker) And bridge the 275 amp for a sub? I would not use the HU to power any speakers.

My door is like that, except the hole is not covered. Since i was planning on mounting it to the door panel, i read in some other posts, that would be unecessary. Is building a door pod more complicated than taking a MDF board and bolting it to the door panel, and then covering it in fabric...

I have already deadened the metal on the door (both parts of metal), as well as the door panel. Just want to make the installation a little firmer.

Hi, just need a little help here. I have some Quart RCE216's, they are screwed onto the door panel of my car, (94 Geo prizm) so the panels are very flimsy. I want to achieve a better low end. So what i want to do is mount the speaker on a MDF board that will be screwed onto the door panel. Will...

should be 4" front and 5.25/6.5 rear (with aftermarket bracket) and you can only fit very shallow speakers in the rear. I managed to stick 6.5" in the front though

It is recommended that they only be installed in a Free air enviroment. Don't think sticking it in a box will do you any good.

You would have to find out the part number for it, then look for a electronic shop (easier online) that could send it to you, but this requires you to take apart your HU.

I had a Pioneer HU crap out on me this way, several friends had the same issue w/ their Pioneers, this could be the same. There is a little ribbon that goes from the DIsplay part to the Main unit, and from going up and down so much it wears out and does not make contact. Replacing the ribbon is...

Does any1 know if a program exists where you can use your laptop as an oscilloscope? Maybe use one of the ports on the laptop for your leads?? thanx

Yes...............

Never mind, finally found em, here they are in case any1 is interested: http://www.ihearyou.com/testtones/ http://www.snapbug.ws/sinewaves/

hope someone can help me here, about a month ago, someone here posted 2 links to a place where you could download all different frequencies and stuff to make your own test CD. Anyone know what place that is? I cannot find the place again, and it is drivin me NUTS!! Thanx in advance.