Recent content by bluv
-
B
Amp choosing
the two kickers combined...wired parallel will be a 2 ohm load! the kicker is rated at 300 rms at 2 ohms.......read up on this...Subwoofer Wiring Diagrams, Two 4 ohm Single Voice Coil (SVC) Speakers- bluv
- Post #6
- Forum: Amplifiers
-
B
Amp choosing
That amp should be fine. The subs wired parallel will be a 2ohm load. However this amp matches your subs better.....Kicker 08ZX300.1 (08zx3001) - Monoblock Car Amplifier, Power Amp - Sonic Electronix- bluv
- Post #3
- Forum: Amplifiers
-
B
Hifonics
I didn't think 438.00 Dollars was a lot to pay for 2000 watts @ 1.5 ohms. Please If you know of better deals let me know!- bluv
- Post #5
- Forum: Amplifiers
-
B
Hifonics
two 13w7s as stated in my original post. I will need 2000 watts at 1.5 ohms If there are better choices please let me know Thanks- bluv
- Post #4
- Forum: Amplifiers
-
B
Hifonics
looking for opinions which one for two jl 13w7s Hifonics BRZ2400.1D Mono Class D 2400 Watt 1 Ohm Stable Amplifier Hifonics HFi2500D Class D 2500 Watt 1-Ohm Stable Amplifier (HFI 2500)- bluv
- Thread
- Replies: 5
- Forum: Amplifiers
-
B
Jl audio gmax 1200
I am not necessarily going to try it! I was just bouncing ideas off you guys! I thought if it was turned down a little the lower impedance wouldn't hurt it,but if you guys say it's a nono then so be it!- bluv
- Post #10
- Forum: Amplifiers
-
B
Jl audio gmax 1200
What if I set the gain a little lower say 38 vac=1000 watts.- bluv
- Post #8
- Forum: Amplifiers
-
B
Jl audio gmax 1200
I have a gmax amp and was wondering if it would be safe to run at 1.5 ohms.The manual gives specs down to 2 ohms.Would half an ohm less be damaging?- bluv
- Thread
- Replies: 9
- Forum: Amplifiers