Recent content by bjanicek

I have an inline fuse that blew when they were wired backwards. After I switched everything, no fuse blew, turned on like normal and smoked after a few seconds. I cracked it open and there is no visual damage but that doesn't mean something still isn't fried. I don't want to cause more damage...

Sorry, I had them wired in parallel. Got myself confused, they have digital readout and were setting nicely at 12.3V

I had two caps in series before the amp and the wires to the amp from the second cap were backwards but I didn't have the trigger wire installed. Disconnected power, switched wires and installed the remote wire. Connected to battery and then it smoked.

Well that's unfortunate. It is probably about 3 years old. worked great originally but I got a new car after my accident and it's been sitting for months now.

Hifonics Brutus BRX 2000.1D

I also had my subs connected at 1 ohm and a pre-amp connected. The amp is stable at 1 ohm and the subs are dual 4 ohm voice coils. I was going to test everything but as soon as I hooked the battery up this happened. Could any of that play a factor?

I know that this amp worked as it was in another vehicle before. I hooked everything up to make sure it still worked after it was ran at low voltage after an accident. About 5 to 10 seconds of power being supplied I heard a small pop and some smoke rolled out. I immediately disconnect power but...