Recent content by bigwyrm

Anyone got info on this amp or the new phoenix gold lines in general?

So both front and rear should be getting the exact same signal. If each front and rear channel has its own gain dial just tune them to where they sound even. Just be careful not to induce clipping of the signal.

That amp bridged would work well to power 1 sub with a little bit of headroom left, but would probably be better suited driving a pair of component speakers. I would suggest a small mono-block for the subs. Be careful with that 1000W peak rating on the woofers, I can promise if you send one of...

It's absolutely nothing to worry about. You could easily swap the wiring to fix the issue being careful not to mix things up. The amp will be putting out the same power to front and rear unless they are running different impedance or you have the signal faded. Do you have 2 sets of RCA's from...

Fosgate is a decent brand, I can't speak personally to their amps or the one you referenced but I owned a cheap pair of their SPL subs which were really loud on very little power but they eventually failed on me. They were factory refurbs when I bought them, and had them replaced under warranty...

I'm sure there may be amps out there that are just as capable and cheaper, but I would at least consider the Phoenix Gold Elite 3200W - 1ohm if you have the budget. I have owned several of their products which always do more than rated power and from my experience have never failed. I am...

Hey guys, first post here looking for some advice and comments. I am about to pull the trigger on a Phoenix Gold RX600.5 amplifier for my new f-150 super crew. The features I need/want are 5 channel for upgrading 2 comps, 2 coax, & 8" sub Hi-level inputs to integrate factory sync...